I love my challah, but use this recipe sometimes if I'm feeling like something a little different or if I want to make 2 loaves.
honey challah
makes 2 loaves.
3 ½ t active dry yeast
¼ cup warm water (105 to 115 degrees)
pinch of sugar
¼ cup mild honey
¾ cup cold water
2 large eggs, plus 2 large egg yolks
¼ cup corn oil, or other vegetable oil, plus additional for the bowl
4 ½ cups unbleached all-purpose flour, as needed
1 ½ t fine sea salt
- sprinkle the yeast over the ¼ cup warm water, in a small bowl, with the pinch of sugar. let stand for 5 minutes to soften the yeast, then stir to dissolve.
- pour into the bowl of a stand mixer. add the ¾ cup cold water, the honey, the 2 eggs, the yolks, and oil and whisk to combine.
- attach the bowl to the stand mixer fitted with the paddle attachment. on low speed, gradually add half of the flour, and then the salt. gradually mix enough of the remaining flour to form a soft, rough dough that cleans the bowl.
- replace the paddle attachment with the dough hook. knead on medium-low speed until the dough is smooth, soft, and elastic, about 6 minutes.
- transfer the dough to a lightly floured work surface. knead briefly to check the dough’s texture. it should feel slightly sticky, but you can knead in a little more flour if necessary.
- lightly oil a large bowl. shape the dough into a ball and place, smooth side down, in the bowl. turn to coat the ball with oil, ending with the smooth side up. cover the bowl tightly with plastic wrap. let stand in a warm place until doubles in volume, about 1 ½ hours.
- working carefully to preserve the dough’s light and puffy texture, turn the dough out onto a clean unfloured work surface. do not knead the dough. gently shape the dough into a thick rectangle and cut the dough into 6 equal pieces. for best results, weigh each piece on a scale.
- in order to roll the dough into ropes for braiding, there must be some traction between the dough and the work surface. the tiniest bit of flour will make the surface too slick. to remedy this, scrape your work surface completely clean. using a damp kitchen towel, wipe a very thin film of water on the work surface.
- working with one piece of dough at a time, shape into thick cylinder. starting at the center and working outward, roll the dough back and forth on the work surface, pressing down the dough at the same time, slowly moving your hands apart as you roll until the dough is stretched into a 13-inch-long rope, with the center of the rope plumper than the two ends. repeat with the other 5 ropes. as the ropes are formed, cover them loosely with plastic wrap.
- line two half-sheet pans with parchment paper. vertically line up 3 ropes next to each other. begin the braid from the center to one bottom end, dropping the ropes loosely into place without stretching them. when you have finished half the braid, pinch the ends together. flip the dough over with the unbraided ropes facing you. braid from the center to the other end, and pinch the ends together. turn the dough over again, and transfer to a prepared pan. be sure that the ends of the loaf are pinched and the points are tucked under. repeat with the other 3 ropes of dough and transfer to a second prepared pan.
- choose a warm spot in the kitchen for the proofing. let stand until the braids look quite puffy and seem a bit more than doubled in volume, 45 to 60 minutes.
- meanwhile, position racks in the center and top third of the oven and preheat to 375.
- bake the breads for 15 minutes. switch the position of the breads from top to bottom and front to back. reduce the oven temperature to 350. and continue baking until the loaves are golden brown and the bottoms sound hollow when tapped with your knuckles, about 30 minutes. if the loaves seem to be browning too deeply, cover them loosely with aluminum foil. transfer the loaves to a wire rack and cool completely.
No comments:
Post a Comment